Saginaw Thermal Calculator -

where ( k ) was a quenchant-specific constant (oil, water, or polymer). She plotted families of curves for rounds, flats, and complex shapes. Then she built a — a circular slide chart with three movable disks.

The story took a twist in 1965. A quality auditor noticed that Mira’s formula consistently overpredicted cooling for hollow shafts. She went back to the data, found a second-order boundary layer effect, and issued a — a small correction table printed on the back. Operators grumbled about flipping the card, but the new accuracy caught a latent problem: an oil quench tank that had been slowly contaminated with water. That discovery alone saved a $250,000 recall. saginaw thermal calculator

Mira Kostic eventually left Saginaw to teach at Lawrence Tech. But the calculator lived on. Well into the 1980s, old-timers would pull yellowed Saginaw Thermal Calculators from their toolbox lids, ignoring the new digital infrared guns. “Batteries die,” they’d say, spinning the cardboard disk. “This never does.” where ( k ) was a quenchant-specific constant

In 1993, the plant closed. But a few original calculators survive in private collections — not just as industrial archaeology, but as proof that a sharp mind with a slide rule and a stack of data can solve a problem that computers (in 1957) couldn’t touch. If you’d like a visual schematic of the nomograph or the exact formula’s derivation, let me know. The story took a twist in 1965

[ T_{core}(t) = T_{furnace} - \left( \frac{k \cdot t}{ (V/A)^{0.85} } \right) ]

Within six months, scrap rates from thermal cracking dropped 43%. Dutch had the tool laminated in greaseproof plastic and chained to every quench tank. Mira’s design was so effective that the plant manager sent copies to GM’s Hydra-matic and Detroit Diesel divisions. By 1962, over 2,000 Saginaw Thermal Calculators were in use across the Midwest.

By aligning the part’s “minimum section thickness” with its “mass,” and reading across to “time since quench,” a line operator could instantly estimate the core temperature to within ±15°F. No electronics. No batteries. Just laminated cardboard, brass rivets, and a clear plastic cursor.